Our premium strip kits use strong binding tape for a lasting hold you can trust.

1. To prep the area you wish to mount the LED Strip. Wash the installation point with warm water, then wipe it dry.

2. Dampen a clean cloth in warm water, then scrub the surface to remove debris. Any grime left behind could prevent the LEDs from sticking, so thoroughly clean the surface until it’s free of dirt and scuff marks.

3. Remove any moisture left over with a clean, dry cloth or give the surface 30 minutes to air dry. Next, use the adhesive booster that we provide to wipe the area for a ready to stick surface.

4. Peel the adhesive backing off and press the LEDs in place. LED lights are like stickers, so wait until you’re ready to put them on the wall before pulling the backing off. It’s best to do this a little at a time. Start at one end of the surface, peeling the backing off of the initial LED light. Position it, press it flat by hand, then continue placing the rest of the strip. Take your time. Make sure the LEDs are in the right place so you don’t have to move them later.

• Fuse Tap Adapter Set B0B7QVF6B9
• 12" LED Strip Expansion Pack B00XB7XJO8
• Headlight Restoration Kit B07PYQ1L3G
• Y Splitter B0CYSRNB65
• Mounting Bracket B0CFKY6N9X
• In-line Fuse Power Wire B0C2HBBFN7

NOTE: If you need help troubleshooting, email OPT7 Customer Support Team to assist.