Fire Up Your Engine Bay With LED Lights.

Get ready for a show-stopping entrance at the next car meet! Prepare yourself for a never-ending stream of inquiries like, "Where did you get those?" Introducing our customization SmartColor LED Engine Bay kit, designed to elevate your ride to a whole new level of attention-commanding style.

Your Color, Your Way.

Roll with any theme you want. Whether its to match your rims or rep your favorite sports teams colors, the choice is yours with 16 different custom colors at the push of a button.

Brightness On Demand.

Whether you want daytime bright or something more subtle, discover your ideal hue with our included dimmer. 4 feet worth of SmartColor LED strips make your ride glow like never before.

Built Tough. Built for the Road.

AURA LED Strips are built to last. Constructed and filled with dense silicone. Our kits are designed to protect against road debris, moisture and anything life can throw at it.

Waterproof Connectors are here to stay!

Get OPT7s Aura Engine Bay game-changing lighting system that installs in minutes and lasts for years to come!

E-Z Programming

Once installed, easily select the color and pattern you want with our one feature-rich E-Z Remote.

• 12 Solid Colors
• 19 Modes
• 8 Levels Speed
• 8 Levels Dimmer

Aura Engine Bay Interior LED Light Kit Includes:

• 1 x 21-Key Handheld Remote
• 1 x Aura V2 Control Box (P) + 4-Pin Round Waterproof Pre-Attached Connectors
• 4 x 12” LED Strips with Adhesive Back
• 4 x 10 ft Extension Wires
• 1 x 10 ft Hardwire In-line Fuse Power Harness
• 1 x Pack of Mounting Kit and Zip Ties

Automotive Adhesive Tape

Our premium strip kits use strong binding tape for a lasting hold you can trust.

Tip on applying adhesive LED strips securely:

1. To prep the area you wish to mount the LED Strip. Wash the installation point with warm water, then wipe it dry.
2. Dampen a clean cloth in warm water, then scrub the surface to remove debris. Any grime left behind could prevent the LEDs from sticking, so thoroughly clean the surface until it’s free of dirt and scuff marks.
3. Remove any moisture left over with a clean, dry cloth or give the surface 30 minutes to air dry. Next, use the adhesive booster that we provide to wipe the area for a ready to stick surface.
4. Peel the adhesive backing off and press the LEDs in place. LED lights are like stickers, so wait until you’re ready to put them on the wall before pulling the backing off. It’s best to do this a little at a time. Start at one end of the surface, peeling the backing off of the initial LED light. Position it, press it flat by hand, then continue placing the rest of the strip. Take your time. Make sure the LEDs are in the right place so you don’t have to move them later.