Feature

●Using the same MCU and core circuit as AT AVRISP, easy to use, stable and reliable
●Based on ATMEL official STK500 firmware, identified as AVRISP/STK500 in AVRStudio, high speed programming
●CH340G USB to UART converter, supports most popular OS, including WIN10, more stable, faster programming
●Supports 0~3.6864MHz frequency output (via the two through holes on the backside, round=GND, square=PCLK, frequency is configurable by software)
●Supports AVR Studio 4/5/6/7


Description

Features
Resolution
* Using the same MCU and core circuit as AT AVRISP, easy to use, stable and reliable
* Based on ATMEL official STK500 firmware, identified as AVRISP/STK500 in AVRStudio, high speed programming
Standard
ISP_6PIN connector
CH340G USB to UART converter, supports most popular OS, including WIN10,
more stable, faster programming
Supports AVR Studio
4/5/6/7
Supports
0~3.6864MHz frequency output (via the two through holes on the backside, round=GND, square=PCLK, frequency is configurable by software)

Supported Software
AVR Studio or WINAVR(GCC) is used as front-end software
Supports files generated by IAR, ICCAVR, CVAVR, etc.

Performance
High speed programs FLASH ROM, EEPROM, Fuses, and Lock Bit
It takes only 5.5s to program a 45K program file with verification (the test MCU uses 8MHz external crystal, and programming speed is set as 1.8MHz)

Connects to PC
Uses a quasi-USB interface (USB To COM)
The COM port is configurable, a PC could connects to several USB AVRISP CH at the same time
Note: the COM port should be configured as COM1-COM4 for the first time, refer to the user manual for more details.

Package Contains:
USB AVRISP CH x1
USB cable x1
6-pin to 10-pin ISP cable x1
6-wire multicolour separated cable x1


For more details you may need to know, pls firstly send me message via Amazon,
I will then send attached link including User Guide for you, thank you for patience :)