Step 1. Clean dent surface.
Step 2. Put the glue sticks to gun and heat, connect the power source and preheat for 5-10 minutes.
Step 3. According to the dent size to choose the Glue Puller Tab, then put the heated glue on puller tab, immediately place puller tab in the center of the dent and hold on until it sticks.
Step 4. Let the glue cool for about 5-8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter. (The applicable temperature for glue sticks ranges from 0 to 40degrees. If the temperature dropped below 0 degree, the hot melt glue mayquickly curdle and cannot be sticked. For this case, just heat the joint with a hairdryer before use this product.)
Step 5. After the glue cooling,use a golden dent lifter or bridge puller to align and press the puller to pull up the dent. Repeat the above steps until the dent disappear.
Step 6. After finishing the dent,use the alcohol to clean the glue which on the car and the puller tabs.
Note: For detailed operation and more tools, please refer to the instruction manual. (Tips: This dent repair tool kit can effectively repair 90% of the repair effect, but not repair 100% of the perfect effect. Please read the instructions carefully before buying.)