Feature
●Fully Easy to Install - These door edge guards will protect your vehicle from nicks, chips & scratches.They install easily with no tools. They are U channel design and fit easily over any door edge. Our car door protector works best for door edge thickness up to 5 mm (0.2"). Attention to truck/van owners, please ensure your car door edge thickness prior to purchase.
●Keep Door Edge Well Protected - Vehicle car door edge guards protects each door edge and help maintain the vehicles condition by preventing door dings, dents (when open the door), chipping paint and rust. Protect Your Car Vehicle paint protection doesnt have to involve the entire car from front to back.
●The Way to Use - Sticky double-sided adhesive tape keeps the strip at the door edge securely (use with primer would be better), the sticky part of the strip should go on INSIDE of the door edge. Convenient for DIY installing and removing, less than 20 min. Our car door protector designs Invisible for your car protection.
●Just Take Care of Your Car Now - Act as a door guard against nicks and dings, it look good. For your car offering a literal line of defense to keep the paint there looking as good as the day it was first applied and preserving the integrity of the metal beneath.
●Attention - If the adhesive cannot be firmly attached, you should first wipe the area to be attached with a damp towel and air dry it before applying it. While applying, press lightly to make the adhesive more snug to the area to be attached. Please be careful not to let it go into the water within 24 hours after applying it.
Description
Car Door Edge Guards
Prevent dust, rain, air and noise
Improve air conditioning efficiency
Vibration mitigation
Designed to cover almost any edge of the vehicle, including the luggage compartment lid, hood, doors and grille
Prevent and protect the door from debris and scratches that cause rust over time
|
|
|
|
|---|---|---|
|
1.Clean the door edge to remove any oil, wax & dust. Make sure the door is dry before continuing. |
2.Uncover the tape from the tip of the lining (Ensure the tape is installed INSIDE the door) and peel the red strip off the tape by approximately 2 inches. |
3.Start from the top, insert the lining onto your door edge until the lining is fully seated. |
|
|
|
|
|---|---|---|
|
4.Press the lining with your thumb along the door edge until it is fully seated, then pull the red strip off. Repeat until all edges are protected. |
5.Use scissors to cut away unused lining for other door edges. |
6.Let the lining dry up by itself and do not get wet for at least 12 hours. |
