Feature

●We are located locally and will deliver the product to you as quickly as possible.
●Magnetic Motor Starter. Works in all applications where a separate limit switch is not used to engage the starter.
●This new magnetic motor starter is designed to run equipment where the user controls the starting and stopping. It uses momentary push buttons and a latch auxiliary contact on the starter to hold power until the stop button is pressed. This type of controls can not be used for equipment such as an air compressor. ? Pre-wired for easy installation.
●Model Number: DOL 12-18-240LCS 1PH ? Model Explanation: ? DOL = Across the line starter ? 12-18 = Overload Size ? 230 = Coil Voltage (suitable for 208V - 240V) ? LC = Low cost compact design ? Sized for 3 HP @ 230V 1 phase.
●Motor starters are made up of primarily two parts. A contactor and overload device. Both devices have maximum ratings and the overload has maximum and minimum ratings. You should choose a motor starter that fits both criteria.
●To size your starter properly you must determine the following: ? -Three phase or Single phase ? -Supply voltage ie. 120V; 208V; 230V; 460V; 600V ? -Machine single motor HP ? -Motor FLA (full load Amps) and worst case SFA (service factor Amps)
●If your supply Voltage is 208V and you want to use your supply power to power the contactor coil... Our 230V coils are rated down to 196 Volts. Now, under most cases our standard 230V coil will work flawlessly on 208V systems. But, if your machine is very large for your electrical service OR your wiring run is long or undersized I recommend using a separate 120V source for the coil power.


Description

Magnetic Motor Starter