The StepAbove is proudly made in the USA with the design and quality you can have confidence in.
Upgrade your trailer or 5th wheel with our innovative StepAbove RV entry step system to give you bounce-free, wobble-free stability. With adjustable feet, rough terrain is no problem for your StepAbove. Easily store and lock the StepAbove into your door entrance.
|
|
|
|
---|---|---|---|
Step 1 - ThresholdMake sure the rise of your threshold is between 5/8 and 3/4. If it is greater or less than either of these measurements, the door may not close properly. |
Step 2 - Hinge PlateYou must have a gap of 3/8 from the bottom of your entry and screen doors to the top of the threshold to allow room for the step hinge plate. Without this clearance, your door will not have sufficient room to close while the steps are down. |
Step 3 - Step HeightFind your step height by measuring from the top of the threshold to the ground. |
Step 4 - Door WidthFind the door width on the factory label located on the side or edge of the door. If there is no label, measure the inside at the base of the door from flange to flange and refer to the fit chart below. Please note that the flange to flange measurement is the narrowest part of the door opening. |
|
|
|
---|---|---|
HandrailAdd even more stability and security to your StepAbove RV Entry Step system with a handrail. Although many RVs come with a grab handle preinstalled, they can often be difficult to reach from the ground and awkward to hold while walking out of the RV. The StepAbove Handrail provides more stability the entire way in or out of your RV. Part Numbers:
|
Storage BoxAdd the perfect storage solution to your RV with a Step Storage Box. The lockable, durable design fits the empty mount space after you replace your original step system with the StepAbove RV Entry Step. Part Number: SP54-099 |
Motion Activated LightsIlluminate your path with bright LED step lights that attach to the bottom of the StepAbove RV Entry Step. Simple magnetic attachment feature allows each light to be used as a standalone flashlight. Part Number: STP54-032 |
|
|
|
|
---|---|---|---|
Step 1Remove the step transition strip between the threshold of the existing door and the floor. |
Step 2With the StepAbove in the downward position, center it in the door opening. Adjust the steps until the hinge plate is centered and flush against the threshold. |
Step 3With the StepAbove centered and flush against the threshold, attach one fastener in each of the top corner holes where the plate is notched. |
Step 4Lift the StepAbove and lock into place. Ensure that the latches have engaged with the flange of the door jamb. The latches may need to be adjusted in or out; this can be accomplished by loosening the bolts and sliding it into place. NOTE: Some doors may require the interior wood or trim work to be notched. For assistance with any modification, please call our Parts Department at 574-293-1581. |
|
|
|
---|---|---|
Step 5Lower the steps and then shut both the screen door and the outside door to ensure they close properly with the StepAbove in the lowered position. |
Step 6Raise the StepAbove into the locked position and secure the hinge plate with the (6) remaining fasteners. There will be a gap between the hinge plate and the threshold. NOTE: The legs of the StepAbove are adjustable and may need to be retracted in order to fit inside the door opening. |
Step 7Make sure the StepAbove operates smoothly and aligns correctly. |