Set of 2 Honda, Kawasaki, Suzuki & Yamaha Fork Seals. 35mm x 48mm x 11mm. Fits on tons of different motorcycles. When replacing fork seals be very careful not to scratch or gouge the aluminum during the removal of the old seals. Use a fork seal driver to install the new seals or use the old seal to help drive in the new seal. Be sure to drive it in evenly and make sure it fully seats so the snap ring can be installed. Then get back on the road with oil tight forks!
35mm (inner diameter)
48mm (outer diameter)
11mm (height)
Note: CB450K3-K4 - 1970-1971 Honda made a change in the fork seal size. Check the sizing stamped on your seals prior to ordering.
This seal will not replace: OIL SEAL (35X46X11) | Which was used from Frame SN 4017272
CR80R - 1987-1995
CR125M Elsinore - 1976-1978
NX125 - 1988-1990
XR200R - 1981-1983
CR250M Elsinore - 1973-1976
MR250 Elsinore - 1976
MT250 Elsinore - 1974-1976
VTR250 Interceptor - 1988-1990
XL250 Motosport - 1972-1976
XL250R - 1982-1987
XL250S - 1978-1981
XR250 - 1979-1980
SL350K - 1972-1973
XL350 1974-1978
CB450K Super Sport - 1970-1974
CB500K Four - 1971-1973
CB500T Twin DOHC - 1975-1976
CX500C Custom - 1981-1982
GB500 Tourist Trophy - 1989-1990
GL500 Silver Wing - 1981-1982
GL500I Silver Wing Interstate - 1981-1982
XL500S - 1979-1981
XR500 - 1979-1980
CB550F Super Sport - 1975-1977
CB550K Four - 1974-1978
CB650 - 1979-1982
CB650C Custom - 1980-1981
CB750A Hondamatic - 1976-1978
CB750C Custom - 1980-1982
CB750F Super Sport - 1975-1980
CB750K Four - 1969-1982
CB750L Limited Edition - 1979
CBX Super Sport - 1979-1980