Feature

●NGK Spark Plug Resistor Cover - LB05F for the CB350 twin and most of Hondas other twins from the 60s and 70s. This one has a 90 degree bend. For 14mm thread spark plugs without the terminal nut. Rubber waterproof boots to seal out the elements. We recommend using non-resistor type spark plugs when using resistor caps.
●NGK spark plug resistor covers are the best protection against radio frequency interference
●Rubber waterproof boots to seal out the elements, so the engine wont cut out if it rains.
●For use with 7mm diameter plug wires
●Fits all Honda Twins from the 60s and 70s plus a lot of single cylinder 4 strokes and 2 strokes


Description

NGK Spark Plug Resistor Cover - LB05F for the CB350 twin and most of Hondas other twins from the 60s and 70s. This one has a 90 degree bend. For 14mm thread spark plugs without the terminal nut. Rubber waterproof boots to seal out the elements. We recommend using non-resistor type spark plugs when using resistor caps on vintage Hondas.

NGK Part Number: 8030
Replaces Honda Part Number: 30700-098-153

Installation tips:

Remove terminal nut before installing new spark plugs. Its screwed onto the top of the spark plug.
Put a light coating of anti-seize on the spark plug threading before installing. After all, youre threading a steel part into a aluminum engine case.
Dont over tighten the spark plug, 1/8 to 1/4 turn past finger tight.
When using the old spark plug wires, trim them back 1/4" - 1/2" to expose fresh wire, then using a pick type tool, fan out the wires before threading on the new resistor cover.
Twist on the new cover about 3 full turns and give it a tug to make sure its snug.

Also fits tons of other bikes. Check the part number and photo to see if its what you need.