Feature

●SOFTWARE: Organic Light Emitting Diode mini standing meter software, which modifies the nonlinearity of diode by 1024 point interpolation algorithm, and has the ability to display standing , peak forward power PF, peak reverse power PR, average forward power AF and average reverse power Ar at the same time. The use frequency is 1.6?30MHz, and the maximum measurement power is 100W.
●HARDWARE: The hardware of Organic Light Emitting Diode mini standing meter adopts 2.23 inch 128x32 resolution orange Organic Light Emitting Diode screen as the display screen, which is served by mega32 of AVR, MCU, built inlithium battery with capacity of 350 Ma and 8.4v, 5V (Micro USB) charging. The standing detection part adopts three magneticdetection circuit and M type (sl16) connector.
●DISPLAY CONTENT: When the standing meter starts up, first display the world map, then display the version number and the percentage value of battery voltage, and then enter the main measurement interface. At this time, if there is a signal, the standing and corresponding power value will be displayed.
●CHARGING INDICATOR: The charging LED indicates that it is always on during charging and goes out after charging. In case of input overvoltage, output undervoltage and overvoltage, output short circuit and timeout of charging time, it flashes at the frequency of 1.6hz.
●CHARGING NOTe: Do not charge your wife after the battery port is exhausted. If the battery is exhausted and the standing meter cannot be started for charging, the red LED indicator in the charging port will be dark. At this time, do not unplug the charging plug. After a few minutes, plug andunplug the charging plug several times. When the charging light is normal brightness, it will enter the normal charging state.


Description

Specification:
Item Type: Standing Meter
Product Material: Aluminum Alloy
Battery: 350 MAh Li IonBattery (Built In)
Display: 2.23 Inch Organic Light Emitting Diode Screen
Resolution: 128x32
RF Connector: Sl16?kf (m?kf) Female Chassis
Frequency Range: 1.6?30MHz
Power Error: ±5%
Maximum Measurement Power: 100W
Maximum Display Power: 138W
Standing Display Range: 1.0?10
Insertion Loss: Less Than 0.1dB
Impedance: 50Ω
Charging Port: 5V

How to Use:
The left m base of the standing meter is the input terminal (connected to the radio station), and the right m base is the output terminal (connected to the antenna). Turn the power switch on the right side of the standing meter.

Packing list:
1 x Standing Meter
1 x USB Cable