Holybro RemoteID Module is a low-cost, small-size, and lightweight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols and is an FCC and CE-approved radio module. The product runs open-source firmware (ArduRemoteID) and provides a standard Remote ID solution, primarily targeting drone manufacturers and system integrators.NOTE - this is not a standalone remote ID module! A flight controller running Ardupilot is required! This product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, as you need to do your approval process at the FAA (DoC submission) if you are in the USA. For the most accurate and latest information related to this topic, please refer to the official governance website of your country.VIDEO: (Insert Video Title here in Bold)FeaturesStandard Remote ID SolutionBroadcasts InformationOpen-Source FirmwareFCC and CE-ApprovedTargeted AudienceProtocol SupportLightweightSmall-SizeLow-CostUSE BULLETED FEATURE HERE IN BOLD CAPS.Add additional feature descriptions here to describe the above.USE BULLETED FEATURE HERE IN BOLD CAPS.Add additional feature descriptions here to describe the above.SpecificationsFirmware: Supports upgrading firmware via the web interface ("OTA")Power: 5V supplied from TELEM or CAN portAntenna Connector Type: SMA ConnectorRadio Module: Espressif ESP-C3 moduleOperating Temperature: -40°C to +85°CRange: > 5km detection rangeProtocol: CAN & SerialMount: M2 screwsWeight: 27.5gIMPORTANT NOTESInsert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."Recommended (Not Included) (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")Links (Insert links such as manuals, firmware, etc)Includes1x Holybro Remote ID1x Antenna2x CablesFeatured VideosADD VIDEO TITLE HERE IN BOLD CAPSADD VIDEO TITLE HERE IN BOLD