Feature

●-ESC: The continuous current of 60A 4 in 1 ESC is 65A*4, the burst current is 65A for 10 seconds. Support 3~6S lipo and Dshot300/600 PWM.
●-LED Pad: Supported LED, 5V, and GND pads are on the bottom of the front side. Used for WS2812 LED controlled by Betaflight firmware and INAV firmware, made your model fly at night.
●-GPS & 16M Blackbox: Equipped with a GPS pad and 16M black box, after you solder up your GPS, you can track the flight trajectory of your model and the black box will record the flight process.
●-Firmware: The firmware is Betaflight Configurator. You can connect the flight controller stack with your computer to adjust and observe the data that you want.
●-Parameter: The MCU is STM32F722RET6, IMU is MPUICM42688. The mounting dimension is 30.5 x 30.5mm, hole diameter is 4mm. You can according to these choose whether it fits your models or not.


Description

Specification:
F722 Flight Controller Stack:
MCU: STM32F722RET6
IMU(Gyro): ICM42688
USB Port Type: Type-C
Barometer: BMP280
OSD Chip BetaFlight: OSD w/ AT7456E chip
Mounting: 30.5 x 30.5mm( 4mm hole diameter)
Dimension: 37(L) x 37(W) x 6.6(H)mm
Weight: 7.5g

55A 4-in-1 ESC:
Firmware: BLS 16.7
Continuous Current: 60A * 4
Burst Current: 65A(10 seconds)
TVS Protective diode: Yes
External Capacitor: 35V560uF
Low ESR Capacitor(In the package)
ESC Protocol: DSHOT300/600
Power Input: 3-6S Lipo
ESC Telemetry: Not supported
Mounting: 30.5 x 30.5mm( 4mm hole diameter)
Dimension: 43(L) * 43(W) * 6.2mm(H)
Weight: 12g