An ergonomic detecting harness that allows for weightless metal detecting in superior comfort
Suitable for people of different heights.
Belt width: approximately 2″
Belt loop width: approximately 3″
technology employs three biomechanical strategies to transfer the detector mass
(weight) away from the operators arm:
remove flexion and extension muscle strain,
use solid skeletal structure to support loads,
avoid soft tissue anchor points.
These effectively remove the need for the arms muscles to tense in a flexion
extension position while swinging the detector, and therefore prevent the muscle
fatigue and soreness that is commonly experienced with metal detecting.
technology also allows the arm to freely medially rotate and abduct to swing the
detector without the need to hold it up off the ground.
Most traditional bungy and harness systems are only effective at removing the load
from the upper arm and forearm, leaving the shoulder to bear the weight of the
detector. Other systems attempt to rectify this by using a strut to transfer the
weight from the shoulder to the front of the hip in a concentrated point. However, this is a soft tissue area and incapable of supporting a load without
discomfort. Additionally, since this area of the body is soft, the strut sinks into the
hip and pulls down on the shoulder, thus becomes ineffective at releasing the
strain in the shoulder.
Note: The product does not contain J-strut, please do not initiate a refund request for not J-strut.