High-strength steel self-made bicycle hook, fixed on the load-bearing wall, hooked to the bicycle triangle crossbar, used for parking bicycles, saving space. Can also be used for bike displays in bike shops.
Accessories: 4 metal screws, 4 plastic expansion tubes (send 4 all-metal expansion screws)
Product features: The angle can be adjusted by 45 degrees, and the length can be adjusted by 25-36 cm
1. The hook position is connected by screws, and the angle is adjustable.
2. The thick steel plate is directly bent, not welded, and will not break
3. The iron pin is connected to the body with steel wire and lanyard, so don’t worry if it falls off and can’t be found
4. 8mm steel pin, firm and not afraid of pressure
5. The surface of the hook is covered with a layer of soft black plastic to prevent scratching the bicycle
Installation method: It is recommended to drill holes with an 8mm drill bit for all-metal expansion screws, and it is recommended to use a 10mm drill bit to drill holes for all-metal expansion screws. lead to slippage)
Step 1: Put the hook base on the wall and mark the positions of the 4 holes with a pen or other tool.
Step 2: Use an electric drill or an impact drill with a concrete drill bit to drill a hole to a depth of about 5-6 cm
Step 3: Put the white plastic bolt into the hole and fix it slightly. The base is aligned with the hole and screw it in. Just tighten it! !
Note: When installing, make a pull test and then hang the bicycle after the latch is installed below!