Feature(may vary by option.)
●SPECIFICATION:Air manifold with connector working pressure is 0?0.9Mpa (0?0.92kfg/cm²),with standard G1/4 thread,adaptation temperature is 0-60℃,connector inner diameter is about 13mm / 0.5in
●EASY TO INSTALL:The multiple way manifold block is small and compact,easy to install and has good airtightness,convenient to use and store
●APPLICABLE:Air hose manifold block splitter is widely used in engineering projects such as factories,automation equipment,auto repair,electronics,etc,wide application range
●MATERIAL:The pneumatic manifold block is made of pure aluminum,wear and resistant,and not easy to rust,pressure resistance is 1.0MPA (10kgf/cm)
●STAINLESS STEEL BEAD:The straight air manifold connector has built in high strength stainless steel bead,with tight buckle,and the operation is simple,offer you better using experience
[SML-2]
[SML-6]
Description
Spec:
Item Type: Air Distribution Block
Material: Aluminum + Stainless Steel
Pressure Resistance: 1.0MPA (10kgf/cm)
Working Pressure: 0-0.9Mpa (0-0.92kfg/cm²)
Adaptation Temperature: 0-60℃
Connector Inner Diameter: Approx. 13mm / 0.5in
Specification:
Model Total Length Ways / Holes Length x Width Thread Center Spacing
SML-2 65mm / 2.6in 2 Ways 5 Holes 20 x 20mm / 0.8 x 0.8in G1/4(12mm) 30mm / 1.2in
SML-3 95mm / 3.7in 3 Ways 6 Holes
SML-4 125mm / 4.9in 4 Ways 7 Holes
SML-5 155mm / 6.1in 5 Ways 8 Holes
SML-6 185mm / 7.3in 6 Ways 9 Holes
packing list:
1 x Air Distribution Block
Notice:
1. Do not unplug and insert the hose frequently during the use of the connector, which will affect the service life of the connector and hose
2. The pipe inserted into the connector needs to be inserted to the bottom of the joint to avoid the possibility of air leakage
3. When pulling out the hose, first confirm that there is no pressure in the tube, press the end cap of the joint to the end and pull out the hose
4. Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.