Spec:
Item Type: Solder Sucker
Model: DP-366P
Material: ABS
Application: Widely used in factories, soldering stations, etc.
Maximum Suction: 40cm-Hg
How to Use:
1. Make sure that the spring?loaded (top) mechanism of the pump is not depressed (if the metal rod in the coil shows, it is not depressed).
2. Hold the pump body, unscrew the plastic flange buckle, and rotate 1/4 counterclockwise at the connection point and the pump body.
3. Pull the valve body away from the spring?loaded (top) mechanism to expose the plunger.
4. Clean (on the ring and inside the housing) solder.
5. Apply lubricant to the metal area of the plunger mechanism.
6. Reassemble the plunger mechanism, pump body and spring?loaded (top) mechanism.
7. Turn the plastic flange buckle clockwise until it locks, and make sure that the upper and lower connections are tight.
PackageList:
1 x Solder Sucker