Feature
●The back cover that has undergone rigorous functional testing and appearance quality inspection is for LG G8S ThinQ LMG810 LM-G810 LMG810EAW This item is perfect to replace your cracked back panel case.
●The installation is require skill and patience, the tool kit in this set is able to complete 100% of the replacement project. This Back Cover will come with these parts (not including any other not mentioned parts) : Pre cut adhesive
●Material : Acrylic Glass
●Please check the installation instruction by rolling to lower part of this page.
●This is a Back Panel Cover Replacement Kit, help to replace the damaged original back cover, come with all the toolkit and adhesive.
Description
Step 1:
Remove the sim card tray.
Use a hair dryer to heat evenly along the edge of the back cover of the phone, about 2-3 minutes
Notice
- Do not stay in one position for too long to prevent overheating
Step 2：
Try to pull and open a gap between back cover and frame after heat. Insert into a guitar pick or card to cut the sticker.
Notice
- If the back cover is seriously damaged, you can paste some tape and then use the suction cup
Step 3：
Gently open the back cover like flipping the page of a book.
if the back cover is made of glass, be careful from cut your fingers with broken glass.
Notice
- Don’t pull the back cover forcefully, or the cable of the small parts will be pulled and broken
Step 4：
Lay the device down and notice that there may have some flex cable will be attached to the back cover with a wire (like the picture). Carefully remove the parts/flex cable upward from the back cover and place it near the battery.
Remove adhesive residue from the edges of the phone, and remove broken glass that has fallen into the phone from the back cover
The parts/flex cable may be glued in so treat with care and remove the parts/flex cable by gently moving your finger around it and lifting up.
Notice
- Patiently and carefully
Step 5：
Reinstall the parts/flex cables you just removed on the new back cover and test all the device function before snap the back cover lightly like closing a book.
Only apply enough force to snap the back cover.
Tear off the new back cover adhesive protective film, gently align the mobile phone and stick the back cover, and after fixing the position, gently press the fixing adhesive along the surrounding area.
Notice
- Do not stain the rear lens glass of the back cover
Step 6：
Hold the phone tightly with a rubber band for 3 hours to allow the adhesive on the back cover to fit well.
Notice
- When adhesive is not strong enough, apply a small amount of B7000 glue on the adhesive