Feature

●PRE INSTALLED FOR ENGRAVE: The roller engraving module comes with pre installed for easy setup. This kit is plug and play and can be used to engrave cylindrical objects such as pens and cups
●WIDE COMPATIBILITY: Support for LaserGRBL, LightBurn, etc., suitable for most desktop engravers. If youre not sure about compatibility, look at the stepper motor specific wiring diagrams below and check
●TO ADJUST: Ideal for most types of desktop engravers, where you can adjust the Z height or reposition the base to accommodate the required clearance for the rollers
●GASKETS WITH SCREWS: Adopt aluminum alloy gaskets and screws to combine, the overall appearance is more beautiful, very practical
●ADJUSTABLE WIDTH RANGE: roller engraving module possess adjustable width for level 5, diameter 20mm to 80mm can be used

Description

Specification:
Item Type: Roller Engraving Module
Motor: No. 17 stepper motor
Model: 17HS4401
Step Angle: 1,8° ± 0.09°
Rated Voltage: DC 3.6V
Rated Current: DC 1.5A per phase
Holding Torsion: ≥420mN.M
Maximum No Load Starling Frequency: ≥1900 PPS
Weight: 255 g / 9 oz(approx.)

Package List:
4 x Aluminum Alloy Gasket M3
8 x Aluminum Alloy Gasket M4
4 x Aluminum Alloy Gasket M5
2 x 2020 L200mm
4 x Flange Bearing
2 x Drum
4 x Timing Pulley Fixing Plate
1 x Motor Side Plate
1 x Side Board
1 x 20 Teeth Synchronous Wheel Inner Hole 5
2 x 20 Tooth Synchronous Wheel Inner Hole 6
1 x No. 17 Stepping Motor
1 x Screw Nut Package
1 Kit
1 x Rubber Timing Belt
1 x Motor Wire
2 x Limit Ring
1 x Idle Gear
1 x User Manual

Notice:
Peel off black film before use to provide adequate functionality.Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.