1. Adopt ARM Cortex?M3 (STM32F103C8), and include a 2.4?inch color TFT display screen.
2. Used for secondary development on the basis of this kit, for example, it can be changed to Millivoltmeter, data loggers.
3. Come with instructions, easy to install and operate, with Auto/Normal/Single trigger modes, easy to the moment waveform.
4. Available rising or falling edge trigger, observable previous waveform before trigger(negative delay), can freeze waveform display at any time(HOLD function).
5. With waveform parameter digital display, including frequency, period, pulse width, duty ratio, Mmaximum./MIN./AVG./?/virtual values.
6. With TFT controller recognition and waveform storage function, will not lose the waveform after power off.
7. Short?circuit and open?circuit detection: can help the user find out the soldering error, the SMD has been soldered, more suitable for electronic beginner.
Spec:
Item Type: Digital Oscilloscope
Material: Engineering plastic
Purpose: DIY oscilloscope
Maximum Real-time Sampling Rate: 1MSa/s
Analog Bandwidth: 0-200KHz
Sensitivity Range: 5mV / div-20mV / idv
Maximum Input Voltage: 50Vpk (1x probe)
Input Impedance: 1MΩ / 20pF
Accuracy: 12 bits
Record Length: 1024 points
Coupling Mode: DC / AC / GND
Time Base Range: 500s / Div-10us / Div
Trigger Mode: Automatic, normal and single
Trigger Position: Buffer center
Power Supply Voltage: DC 9V (8-10V)
Package List:
1 x Oscilloscope
1 x Test Chuck
1 x User Manual
Note:
Please note that the kit does not include a power supply, users need to prepare their own power supply, the power supply current should be able to provide more than 200mA. 9V is recommended