[Spindle Diameter 80mm]
Applicable materials: acrylic, aluminum base board, plastic board, two-color board, density board, and other materials, especially the thin board below 1 cm.
Product features: do not need clamps, only need a small amount of 3 seconds glue, saving 95% of the maximum manpower.
Carved out of the qualified rate of products can reach 100% (unless considered factors) engraving size accurate.
It has the effect of noise silencing and dustproof, and does not affect the change of knife.
Presser automatic expansion range of 2 cm or so.
Production process: local welding, turning processing, quenching treatment.
Working temperature: 1 times higher than the working conditions required by engraving machine itself.
Installation method: the pressing device is set on the main shaft of the engraving machine, adjust the upper and lower positions, tighten the screws, the required positions: the pressing plate below 3MM, the bottom of the pressing plate is parallel to the sharp knife, the plate plate is 4mm-6mm thick, the pressing device is up to 23MM, and so on.
Maintenance method: regular to press the bottom of the ball internal force spray oil can.