Feature

●The module adopts high-quality relay, and the maximum load of normally open interface: AC 250V/10A, DC 30V/10A
●SMD optocoupler isolation, strong driving ability and stable performance, Trigger current 5mA
●The module can set the high level or low level trigger through the jumper
●The interface design is humanized, and all interfaces can be directly connected through the terminal block, which is very convenient
●Module size: 50mm * 26mm * 18.5mm (length * width * height) Equipped with 4 fixing bolt holes, holes 3.1mm, spacing 44.5mm*20.5mm


Description

Description

A module description:
1. the module uses quality relay. normally open interfaces Maximum load: AC 250V/10A. DC 30V/10A,
2. using SMD optocoupler isolation. driving ability. stable performance, trigger current 5mA,
3. the module voltage is 5V. 9V,12 V. 24V are available,
4. the module can be set to high or low triggered by jumper,
5. fault-tolerant design. even if the control line is broken. the relay will not operate,
6. the power indicator (green). relay status indicator (red)
7. interface design humane. all interfaces can be connected directly via terminal wiring leads. very convenient
8. module size: 50mm * 26mm * 18.5mm (L * W * H)
9. has four mounting bolts holes. hole 3.1mm. 44.5mm * 20.5mm pitch

Two module interface:
1. DC +: positive power supply (voltage required by the relay. there 5V.9V.12V and 24V choice)
2. DC-: negative power connection
3. IN: can be high or low level control relay

Relay outputs:
1. NO: normally open relay interface. the relay before the vacant after the pull shorted with COM
2. COM: Common Interface Relays
3. NC: normally closed relay interface relay shorted with COM ago. after the pull-vacant

High and low level trigger selection ends:
1. when jumper short circuit with LOW is low lever trigger,
2. When jumper short circuit with high is high lever trigger.

Package included:
2 pcs 12V 1 Channel Module With Optocoupler Isolation High and Low Level