Feature

●Compatible with ACER H5360 H5360BD V700 H5370BD H5380BD SMART 55 Unifi 55w UF55 UF55W OPTOMA PRO260X PRO360W PRO160S GS316 GS318 SD220U XD220U ES318
●Brand new lamp with new housing. It is NOT just the bare lamp or bare bulb.
●All lamps are produced by our own factory
●All lamps are tested at our factory before leaving the facility
●Cheaper Bare Lamp without Housing Also Available

[Bl-fu240a]




[E20.8]





Description

E20.8E20.8
E20.8E20.8

Projector Lamp Type: Projector Bare lamp

Model number: P-VIP200/0.8 E20.8 Projector Bulb

Compatible with Projector models: Optoma DH1010 EH1020 EW615 EX612 EX615 GT50E GT50ECA GT750 HD1081 HD180 HD20 HD200X HD200X-LV HD20-LV HD22 HD2200 ACER H5360 H5360BD V700 H5370BD H5380BD Smart 55 Unifi 55w UF55 UF55W OPTOMA PRO260X PRO360W PRO160S GS316 GS318 SD220U XD220U ES318

E20.8E20.8

Step 1. Unplug the power cord from your projector and let the lamp cool down.

Step 2. Locate the lamp access panel on your projector and remove the screws and access panel.

Step 3. Remove any screws holding the lamp housing into the projector.

Step 4. Reach in and firmly pull the lamp housing out of the projector.

Step 5. Place the new lamp housing into the projector in the same orientation as you removed the old lamp.

Step 6. Wiggle the lamp into place and make sure full contact is made inside of the projector.

Step 7. Replace the lamp mounting screws to secure the lamp into the projector.

Step 8. Replace the lamp access panel and secure the screws.

Step 9. Plug in your projector and power it on.

Step 10. Reset the lamp counter. Some lamps will reset the lamp counter automatically when a new lamp is placed in.

V13H010L58V13H010L58

V13H010L58V13H010L58

ELPLP58ELPLP58

Where is My Projector Lamp Located

A projector lamp can be found by locating a square or rectangular plastic plate somewhere on the outside of the projector; the plate is usually on the bottom of the projector, but can sometimes be found on the top or sides.

This cover is usually secured by two screws; undo these screws and lift the plate off to reveal the bottom of the plastic housing (the module) that holds the projector lamp in place in your projector.

This plastic housing usually has a handle attached to it. Pull gently on this handle to remove the projector lamp from your projector.

It is time to replace the lamp when:

* Picture has become dull and lacks brightness.

* There is an obvious decline in picture clarity and sharpness.

* Your lamp is flickering.

* There is difficulty or a delay when turning the machine on.

* A light comes on that warns you that it may be time to change your lamp.

Note:

1. Let the lamp cool down before replacing it.

If the lamp breaks, handle the shards

carefully to avoid injury.

2. Do not touch the glass portion of

the lamp assembly. Touching the glass

could result in premature lamp failure.

3. Be sure to seat the lamp fully and

secure the lamp cover. If the lamp is

not properly installed or the cover

is loose, the lamp will not turn on.

Product information