Feature

●Free your CREATIVITY and give your embossing SPARKLE with this set of 4 x 15ml pots of Glitzy embossing glitter, the set includes Green, Blue, Red and White Glitz.
●When it comes to embossing powder, the options are nearly limitless. Whether you want a super shiny effect, matte, antique, distressed, metallic... etc., you will find a powder for it. Think of embossing like pottery, first, you make the pot, then you add the glaze. In card making first we stamp the image, then we add our glaze - the embossing powder.
●These embossing powders WORK WONDERS for when you are using very small or fine-detailed stamps, it will help keep your image CRISP AND CLEAN. These powders are High-quality and NON-TOXIC.
●We always recommend giving your jars a good shake before using, as settling can occur whilst they are being stored.
●Remember working with embossing glitter powders is messy stuff and gets everywhere a good tip is to Put your card or project on a piece of paper that is bigger than the project you are applying the glitter onto. Fold the paper in half first with a good crease, then flatten out again. The paper will catch the overspill of glitter.


Description

Perhaps not the most subtle of finishes but if you want your designs to be noticed, these are the products you need to look at. Free your creativity and give your embossing sparkle. We always recommend giving your jars a good shake before using, as settling can occur WOW! 4 piece Embossing Glitter Glitz Collection| 4 x 15ml pots | Blue White Red and Green Glitz Allow a few minutes drying time for glitter to solidify. High quality nontoxic embossing glitter powder If you are new to the Technique the following is a description of the simplest form of embossing Create a wet image traditionally by inking a Stamp with an embossing ink pad or an embossing pen. Work quickly as the ink must stay sticky while the powder is applied. Sprinkle the embossing powder over the entire area to be raised. The powder needs to stick to the ink, so it is important that the ink is still wet. Remove the excess powder by tapping the sheet and letting it fall back into the container. Stray traces of powder can be brushed off or wiped away carefully. Heat the powder with a heat tool, being careful to apply even heat to the whole area. This is best done from underneath. Move the tool around slowly so as not to overheat or burn the paper. The powder will melt and leave a raised finish. It will take a few seconds to solidify so do not touch the molten powder too quickly