Spec:
Item Type: CNC Engraver Control Board
Material: PCB
Main Board Parameters:
Model: MKSDLC32
Voltage: 12-24V DC (Single Chip Computer: ESP32 WROOM 32U (32 bit)
MCU Frequency: 240MHz
Flash Memory: 8192KBytes
Memory: 520KBytes
Speed: Offline Display: MKS TS24 R TS35 R
Firmware: GRBL
Serial Driver: USB
Axes WIFI Onboard: 4 (X, Y1, Y2, Z)
Website: Support
APP: Support
Storage Card: Support
MKS Tool: Support
Available Machine: CNC engraving machine
Stepper Driver: A4988, DRV8825, TMC2208 2209 2225 (Nema17 motor)
Additional Driver: TB6600 TMC2160 (applicable to Nema23 motor)
: Below 20W (>20W, external power supply)
Compatible Software: For Grbl, for Xloader, for GrblController, for benbox, for mDraw, for LightBurn
Display Screen Parameters:
Model: TS35 R V2.0
Appearance Size: Approx. 110x65mm/4.3x2.5in
Color Touch Screen: 3.5 inch touch screen
Microprocessor: For Cortex M4 main control chip main frequency, 168M main frequency
Update Method: Storage card file update
Support Storage System: Storage card, USB flash drive
Support File Format: Gcode
Expandable Module: WIFI module, power failure relay module, material failure detection switch, external card slot
Stepper Motor Driver:
Model: A4988
Material: PCB, aluminum alloy
Default Current: 2A
Default Reference Voltage: 0.8V
Maximum Current: 2A
Formula: i=Vref/0.8
Current Regulation: Clockwise increase, clockwise decrease
Subdivision: 1, 1/2, 1/4, 1/8, 1/16
Motor: 8-35V, Mode: Direction, Step
How to Use:
Use according to the introduction.
PackageList:
1 x MKS DLC32 V2.1 Main Board
1 x Blue USB Data Cable
1 x TS35 R V2.0 Display Screen
2 x 10 Pin 40cm Flat Cable
3 x Driver
3 x Heat Sink