![Easy to Use](https://images-na.ssl-images-amazon.com/images/G/01/x-locale/common/grey-pixel.gif)
Easy to Use
1.Park the vehicle in a dry and ventilated place away from the fire sources, set "neutral" or "parking", and step on the parking brake.
2.Start the engine to normal operating temperature, and then shut down the engine.
3.Lift the vehicle by car jack. Unscrew the drain plug on the transmission pan, drain old oil by gravity and recover it.
4.Pour the same amount of new oil into the oil can, depending on how much the old oil was emitted. Put the lid on tightly.
5.Select a right ATF adapter and insert it into the quick coupler, close the fluid control valve. Connect the adapter to the fill plug and close the drain plug on the transmission pan. Or connect the adapter to the drain plug if you need fill the transimission fluid from this side
6.Open the fluid control valve, press the hand crank up and down to add new ATF fluid into the transmission until the desired level (Each stroke provides about 70ml). And then follow the vehicle operating instruction to check the transmission fluid level
7.Use clean solvent or engine degreaser to rinse out the oil can and pour it out to waste liquid tank. Allow it to dry thoroughly.
Please note:
1.Please operate under the guidance of professionals and wear protective glasses gloves at all times
2.Fluid temperature range : -3°F ~ 140°F
3.Do not extract the oil over the limited line to prevent any spilling and leaking.
4.If you has some appropriate adapters which can connect to the quick coupler, this transmission filling pump can also be used for manual filling of other oils, such as engine oil, lubricating oil, power steering oil, and other non-corrosive and low concentration liquids