Feature

●【Exquisite Process】The Product Adopts Exquisite Polishing and Painting Process to Create a Smooth, Delicate.
●【Speed ??test】it takes 3 minutes for 0.5L oxygen cylinder to inflate 30MPa, 6 minutes for 1L oxygen cylinder to inflate 30MPa, and 40 minutes for 6.8L oxygen cylinder to inflate 30MPa.
●【Oil/Water Separator】The activated carbon separator on the hose is reusable, which can efficiently filter oil and water in the air, and output clean and dry high-pressure air.
●【8MM Quick Connector&double cylinder】The 8MM female port inflation nozzle can be quickly connected and disconnected. It is suitable directly for nipples of PCP air rifles/pistols and paintball tanks, mini diving bottle, etc.
●【Note】Check the amount of oil before each use, Lubricating oil should exceed the red dot, but not too much. The oil that is exported to foreign countries is taken out and needs to be added by itself. Replace the breathing plug. Change The oil cover used for transportation to a strip-shaped breathing plug.


Description

Specifications:
Voltage: 110/220v
Rated power: 1.8kw
Motor speed: 2800r/min
Working noise: 70dB
Air output: 130L/min
Cooling mode: water cooling
Compression level: secondary compression
Motor material: all copper coil
Cylinder head material: cast aluminum
Shell material: Steel
Pressure range: 0-40MPa
Working pressure: 0-30mpa (4500psi)
Maximum temperature: 80 ℃
Connector type: 8mm quick connect female
Total weight: 20.5kgs

Operation method of electric air pump:
1. Check the amount of oil before each use, Lubricating oil should exceed the red dot, but not too much. The oil that is exported to foreign countries is taken out and needs to be added by itself.
2. Replace the breathing plug. Change the oil cover used for transportation to a strip-shaped breathing plug.
3. Loosen the air bleed screws on both sides before starting the machine(Remember, the machine needs to start under zero pressure. If the bleeder screw is not loosened, the machine will not start. After starting the machine, tighten the bleed screws on both sides to press normally.
4. To install the water pump, you need to put the water pump into the water. The more cold water, the better. After the water pump is normally circulated, the electric air pump can be turned on Manually shut down after reaching the required pressure, the whole process needs attention, and it is forbidden to leave.