Built for Aggressive Work

While there are many types of sanders out there, using the wrong one will make your sanding job a nightmare. Sanding is an important aspect to great wood floors since the electric sander can help repair, restore or refinish hardwood floors.

In a nutshell, Jellas 7Amp 3"x21" belt sander is on the powerful side, able to strip down a piece of wood in a short amount of time. Smoothing and shaping wood best on large, flat surfaces, and can strip off not just wood but coating materials like paint and metal(Should use corresponding sheets for metal sanding). If you’re looking to strip down and finish entire planks, a Jellas belt sander is a good choice because it will offer pretty uniform results across the breadth of its sanding surface. And it is easy to control.

When installing the sanding belt, please keep the arrow on the belt in the same direction of the arrow on the machine, which enables the belt a longer life, avoiding leaving scratches on the board.

Carbon brushes are a very important part of the 7Amp sander machine. Jellas high-quality carbon brushes make the belt sander have a longer service life.

The dust bag has higher dust collection efficiency than the dust box, and the dust bag has air permeability to prevent dust from entering the motor again, so that the service life of the belt sander is longer.

The 3"x21" sander machine comes with 10pcs Sanding Belts (2pcs 40 grits, 2pcs 60 grits, 2pcs 80 grits, 2pcs 120 grits and 2pcs 180 grits aluminum oxide sanding belts), they satisfy more needs of the change of the bands.

The belt sander includes a 2 in 1( 32mm and 35mm) vacuum adapter to connect to a vacuum cleaner.

Warm Tips

√Always ensure that the machine is switched off and plug is removed from the power point before making any adjustment.

√Run the sander for a minute or to ensure correct alignment before using the sander on a workpiece.

√For longer periods of use or on large pieces of work, it is advisable to use a suitable vacuum cleaner. (32mm and 35mm vacuum cleaner ports both fit Jellas Belt Sander)

Steps to attach a sanding belt:

Step 1, Select the required grade of sanding belt.

Step 2, Pull the belt tension lever

Step 3, When attaching a sander paper, please slip a sanding belt by the direction of arrow shows on the sander.

Step 4, Fold down the lever

Step 5, While the belt is running slowly, adjust the tracking adjustment knob to align the belt to the centre of the roller.

Step 6, Repeat the trigger action and tracking adjustment until the belt is aligned correctly.

Step 7, Before using the sander on the workpiece, run the sander for about one minute to ensure correct alignment.

Do not continue to use the sander with a sanding belt that is overworn or damaged. Do not use the same sanding belt for wood and metal. Metal particles become embedded in the belt and will scour a wooden surface.