Specification:
Item Type: Wall Mold Form
Material: ABS
Weight: Approx. 1000g / 35.3oz
Total Product Size: Approx. 49 x 68.5 x 2.6cm / 19.3 x 27.0 x 1.0in
Single Brick Size: Approx. 24.5 x 6.5cm / 9.6 x 2.6in
Application: Suitable for Parks, Garden, Home Decoration
Package List: 1 x Wall Mold Form
Note:
Prepare the molds: Before mixing the concrete, make sure the molds are clean and free of dirt. If it has been used before, clean it with soapy water or industrial alcohol. Brush just a little light vegetable oil or mold release agent into the forms. A mold release agent is recommended, but not required. Not using a release agent will make the stone more difficult to release and you will need to be more careful about damaging the mold. However, too much release agent can cause bubbles to form on the appearance.Mixing concrete.Always wear proper safety equipment when mixing concrete.Mixing can be done by hand using a proper concrete mixer, a wheelbarrow with a concrete hoe, or with a shovel in a bucket. It is very important to take the time to mix everything completely.
Tip:Filling the mold.Fill the bottom of the mold with concrete and tap it firmly to remove air bubbles. Then fill the mold completely to the top and glossy the top appearance by hand so that the concrete is flat and level. Finish the mold by tapping and shaking to get rid of as many air bubbles as possible. Curing and demolding.Once the molds are filled, place the molds on a horizontal table. Cover with plastic wrap and wait less than 24 hours for curing. The plastic wrap covering the concrete will help maintain the humidity in the room, just like a greenhouse, which will minimizeappearance cracking. After the stone has cured, then carefully and gradually pull it up in all directions until it pops out.