Feature

●Floor jack has a 2 ton (4,000 lb) load capacity and features a minimum lifting height of 5-1/8 and a maximum height of 13"
●The 2ton floor jack jack equipped with (2) large steel casters and (2) 360-degree swivel casters for smooth maneuverability
●The floor jack has a large saddle surface area for better contact with the load being supported
●Heavy duty steel construction provides long term durability，Built-in safety valve provides overload protection
●Service jack is built for extra lifting and maneuverability for all load lifting needs. Heavy-duty steel construction provides stability and positioning.


Description

11

capacity:2 ton

Min.Height: 5-1/8"(130mm)

Max Height:13"(330mm)

product size:17-1/4"*7-5/8"*5-1/2"(440*195*140mm)

shipping weight:19.36LBS(8.80kg)

11

? Use only on hard, level surface capable of supporting the load.

? Center load on saddle prior to lifting.

? Support the vehicle with appropriate means immediately after lifting.

? Do not move or dolly the vehicle while on the jack.

? Lift only on areas of the vehicle as specified by the vehicle manufacturer.

11

Air Venting Procedures

? With the jack in the fully lowered position, release valve open, remove oil filler plug.

? Pump the handle rapidly several times. Reinstall oil filler plug.

? Turn the handle/release valve clockwise to the closed position.

? Pump the handle until the lift arm reaches maximum height and continue to pump

several times to remove trapped air in the system.

? Turn the handle/release valve counterclockwise in one full turn and lower lift arm to the

lowest position. Use force on saddle if necessary.

? Carefully and slowly loosen oil filler plug to release pressurized air.

? Repeat above steps until trapped air is completely vented.

11

11

11

Assembly

? If two piece handles are provided, assemble the upper section into the lower section, line up the holes, insert and tighten ? Insert the bottom end of handle into handle fork and securely tighten the bolt and washer. Ensure the handle can turn freely.

Lifting

? Turn the handle/release valve clockwise to the closed position. Do not over tighten.

? Position the jack under the specified lift point.

? Begin lifting by pumping the handle up and down.

? Immediately after lifting, support the vehicle with appropriately rated jack stands.

? Turn the handle/release valve slowly counterclockwise to lower the vehicle onto jack

stands.

Lowering

Turn the handle/release valve clockwise to the closed position. Do not over tighten.

? Pump the handle up and down to lift vehicle off jack stands.

? Remove the jack stands. Do not get under or let anyone get under the vehicle while

lowering.

? Turn the handle/release valve slowly counterclockwise to lower the vehicle onto the

ground.

Product information