Product name: Electric drill drive pump
Product packaging: carton packaging
Working temperature: 5-49℃ (41~1209F)
Product weight: 218g (net weight) 251g (total weight)
Tube inner diameter 15mm
Things to know before buying:
1. In order to achieve the best start-up and prolong service life, add a small amount of lubricating oil to the pump inlet before use and rinse with water after each use.
2. Make sure that the inlet hose is sealed and as short as possible. The hose should not exceed 9 feet (2.75 mete).
3. Working in the temperature range of 50~49℃
4. When pumping abrasives or liquids containing solids, use a filter on the inlet pipeline to obtain a longer pump life.
5. It is recommended to install the pump on the surface for safe use.
6. Install and start the rig. Observe whether there is a certain amount of fluid in the oil inlet pipe being sucked into the pump within 15-20 seconds. If not, check whether the oil inlet pipe is correctly installed on the oil inlet pump. Dont run dry. If the pump fails to start, check whether the hose is kinked or blocked. The pump depends on whether the fluid is a pump for lubrication
7. It is recommended that the speed is 1500-3500 rpm, and the head and flow are related to the speed. The higher the speed, the higher the flow.
1500 rpm, head is about 1.5 mete, flow rate is about 15L per minute
3000 rpm, head is about 3 mete, flow is about 30L per minute
Package Included:
1 x water pump
2 x hose clamp
2 screws
2 x shees
Note:
Please check the model of your refrigerator before purchasing to ensure ordering the correct compatible part.
Since the size above is measured by hand, the size of the actual item you received could be slight different from the size above.