[Quick Mount]

[Chain Stay]

Standard Clamp If your bike has 1 rear sprocket the standard clamp is all that is needed to install the right hand Bike Tow Leash to the right side of your bike. Quick Mount with Clamp Eliminates chain interference on right side installations. Provides extra ease of sharing the Bike Tow Leash between bikes, and rapid adjusting for different dog heights. Use requires minimum of 1 & 1/2 inch flat area surrounding the rear axle. For solid axles 3/8 or 9mm diameter, with hex nuts on both sides, you need 1/4 inch [6mm] available axle length. Installed you will have 5 full turns of thread engagement on the nut. For bikes with quick release lever and 5mm dia. skewers as shown, extra axle length is not necessary. Comes with a 5mm recessed axle nut, 5 & 6mm bolts to engage slot and threaded hole in frame for extra security. Instructions included. The Chain-Stay Clamp Replaces the standard inner clamp to eliminate chain rubbing the inner clamp when the bike is in its highest gears. Right Side BTL mount for use on bikes with rectangular or oval chain-stays (lower rear frame member) up to 1 1/4 inch high. For taller chain stays contact us before ordering. For Bikes with rear suspension where the chain and seat stays move relative to each other so you must clamp just the chain stay. Not necessary for installing on the right side of most single speed cruiser bikes. Also works on manual wheelchair round frame tubes. If for use on a chair or round chain stay, send bike or chair photo make and model before ordering. We have extra shims for custom fits.