Description:
ICL8038 pin functions:
Pin 1, Pin 12: sine waveform adjusting terminal;
Pin 2: sine wave output;
Pin 3: triangle wave output;
Pin 4, Pin 5: the frequency and duty cycle (or waveform asymmetry) adjustment;
Pin 6: V +, the positive power supply;
Pin 7: Frequency Offset;
Pin 8: Frequency adjustment input terminal;
Pin 9: square wave output. This is an open collector output terminal, work should take a load resistor to the corresponding positive power supply terminal from the pin, to get a TTL-compatible square-wave output, the load resistance must be connected to + 5V power supply;
Pin 10: timing capacitor terminal;
Pin 11: V-, negative power supply terminal or the ground. When Use positive and negative power supply, Pin 11 to the negative supply, the output waveform are symmetrical with respect to 0 V; When use a single positive power supply, Pin 11 grounded, the output waveform is unipolar, uniform voltage is + VCC / 2;
Pin 13 and Pin 14: Empty Pin.
The kit is designed for a frequency range is 50-5KHz, two bands with using a switch S to switch, RP1 is the frequency adjustment, RP2 is the duty cycle adjustment, RP3 is a sine wave distortion adjustment. Circuit uses 12V single power supply, input from the X1; X2, X3 is a waveform output side, you can use oscilloscope to observe three output waveforms.
Model: ICL8038
Input: 12V DC
Frequency range: 50-5KHz,
Package Included:
1 * ICL8038 Function Signal Generator DIY KIT
Note: Please contact us if you need the Schematic.