14 Stepper Motor 2?Phase Micro Carbon Steel DC Motors 1.8° 0.22Nm FY35EC180AP
Features:
1. High?quality motor steel sheet, low self?inductance and good responsiveness, can be directly connected to the load and run at low speed without gear reduction.
2. Can produce a high torsion to inertia ratio on the loaded shaft, and can eliminate the system error caused by the use of reduction gears.
3. The inner rotor adopts German technology and the surface is coated with imported rotor glue to prevent burrs on the surface after the carbon steel is oxidized and ground, causing the noise of the motor to increase.
4. The front and rear covers are perfectly connected, the fuselage is black electrophoresis, high?end atmosphere and standard size.
5. With accurate control, the number of pulses determines the position of the motor, quick start and stop, frequent CW and CCW.
Specifications:
Item Type: 14 Stepper Motor
Material: Carbon steel
Purpose: Industrial motor control, transmission transmission scene
Step Angle: 1.8°
Voltage: Determined by the equipped driver, no fixed voltage
Current: 1.8A
Keep Torsion: 0.22N.m
Resistance: 2.7Ω
Inductance: 4.3mH/phase
Length: Approx. 42mm / 1.7in
Number of Outlets: 4
Shaft Type: Milling single flat table
Step Angle Accuracy: ±5% (full step)
Resistance Accuracy: ±10% (20℃)
Inductance Accuracy: ±20% (1KHZ)
Temperature Rise: 80℃ maximum (rated current, 2-phase energization)
Ambient Temperature: -20℃~+50℃
Insulation Resistance: 100MΩMin, 500VDC
Withstand Voltage: 500VAC for one minute
Radial Clearance: 0.02mm maximum (450g load)
Axial Clearance: 0.08mm maximum (450g load)
Maximum Radial Load: 28N (20mm from flange surface)
Maximum Axial Load: 10N
Package List:
1 x 14 Stepper Motor
Note:
1. When connecting the motor to the driver, do not connect the wrong phase.
2