[24V]
How to Use:
Remote controllers and transmitters of the same series and model can be replaced at will as follows:
1. The new transmitter without battery, and the receiver must not be powered on.
2. Install data U disk in each receiver.
3. Insert the small U disk.
4. When the battery is installed, the indicator light flashes three times, the data has been copied to the new transmitter, and it can be used normally.
5. Insert the small U disk according to the direction on the transmitter, the red light flashes three times, and it can be used normally after plugging in the power supply.
Specification:
Item Type: Crane Remote Control
Model: YU 8D
Material: ABS, copper.
Remote Control Battery: 2 x AA alkaline battery, delivered without battery.
Application: For crane, conveyor, CNC, coal mining machinery, generator start, concrete pump, grab bucket and other machinery.
Package List:
1 x Crane Remote Control
1 x Receiver
2 x Dust Cover
2 x Fuse
Note:
1. After use, the main power of the crane should be turned off, and the power of the receiver should be cut off as well.
2. Press the reset emergency stop button of the transmitter, and place the transmitter in a safe place. Personnel should not press it randomly to avoid accidents.
3. The crane should have the main power relay, limit switch, and other safety facilities.
4. Stop using it in case of lightning strike or interference.
5. During installation and maintenance, the main power supply of the crane and the power supply in the receiver should be turned off to avoid electric shock.