Feature

●Thanks for your bid. Item will be shipped by depending on its handling time after your full payment has been received. Rate the seller on the time it took to mail the item, not the time it took you to receive the item!! We ship to Amazon address. Please make sure your address in Amazon is matched with your shipping address before you pay.
●The images are for reference only. Please take the item you get as the standard. Please indicate your personal requirement, such as colors, packages, value of declaration etc, at Amazon message when you pay to us.
●Notes: We will NOT be responsible for any delay during delivery including but not limited to customs postage checking, strike, force majeure etc.
●As a buyer, it is your duty to pay the tax when you make a order from abroad. Our price does not include taxes, VAT, or other hidden charges. Thanks for your kind understanding. If you send email to us,In our working hours will be Reply within 24 hours.
●If you are not satisfied with the product or service ,please contact me and dont give us negative or natural feedback,We must give you a satisfactory solution. Contact us through Amazon message.


Description

Feature:

Product model:SK-66.

Output mode:NO(normally open)

Pre trip:Almost 0

Trip:5mm

Repeat positioning accuracy:0.001mm(operation speed:50-200mm/min)

Life:3000000 times.

Contact force:1.5N

Cutter head:Diameter 20mm, hard carbide.

Shock rating:20mA(MAX) DC24V recommended value(10mA)resistive load

Cable:3M 6-cell tensile strength 30N Minimum bending radius R7

Protection Tube:2M (Minimum bending radius R25)



Ultra travel alarm:

Exceed the specifications:NC(Normally closed),distance signal about 5mm Shock rating:DC24V 20mA(MAX) 10mA(Resistive load).



Installation Instructions:

1. The tool and make sure the contact surface on the knife perpendicular, and vertically downward into contact with the contact surface, please try to install the relatively small iron bench in place

2. Be sure to use within the rated power range, please control voltage DC5-24V, the current below 20mA, the use of ambient temperature range -25oC ~ 70oC.

3. Please knife tool diameter 20mm diameter or less control of the cutting speed please controlled 50-200mm / min, the tool center to fall on the flank of the center.

4. When use of blowing function, the outer diameter of tube diameter 6mm, inner diameter of diameter 4mm. Note that cleaning the contact surface attached to the iron and cutting oil.

Description:
1?Try to put the  screws through the base to the tip leveling during  installation.
2?The cutting speed please controlled 50-200mm / min, the tool center to  fall on  the flank of the center. 
3?Please control voltage DC10-30V, the current below 20mA.
4?The use of blowing function, the outer diameter of tube diameter 6mm.