[24VDC T-A&B to Blocked and P to T in Center Position]
[220VAC H-All Ports Open to Tank in Center Position]
[110VAC T-A&B to Blocked and P to T in Center Position]
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
|
---|---|---|---|---|---|---|
Valve, Duetsch 2-PIN Connector | Valve, Wiring Box and Soft Shift | Valve, DIN Connector | Sub Plate, SA6 Series | Multi Station Parallel Manifold, MPA6 Series | Valve Manual Operated | |
Mounting Pattern Size | D03 or NG6 | D03 or NG6 | D05 or NG10 | D03 or NG6 | D03 or NG6 | D03 or NG6 |
Connector | Duetsch 2-Pin, IP 67 rated for pressure water wash down resistance. | Wiring Terminal Box | DIN 46350 3-Pin, IP 65 rated for low pressure over head water resistance. | SAE -8 hydraulic ports | A and B ports SAE -8. Pressure and tank ports SAE -10. | Manual Lever |
Flow Rate Max. | 21 gpm | 21 gpm | 31 gpm | 21 gpm | 21 gpm | 21 gpm |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
|
---|---|---|---|---|---|---|
Valve, DIN Connector | Pilot Operated Check Module | Flow Control Module | Pressure Reducing Module | Pressure Relieve Module | Single Solenoid 2 Position Valve | |
Mounting Pattern Size | D03 or NG6 | D03 or NG6 | D03 or NG6 | D03 or NG6 | D03 or NG6 | D03 or NG6 |
Use | Directional Control 3 positions | When pressure is sensed in one port it opens the check valve to allow flow in another port. Often used to hold loads until pressure signal received to move. | Use to control flows (speed) of an actuator if supply flow is too great. Can help slow down or soften movements. | Reducing valve reduces the pressure lower than the main system pressure without lowering the pressure of the entire main system. Use for lower pressure rated actuators or to reduce the force or torque. | Reliefs pressure in a port. Protects the system from over pressurizing by bypassing to tank when pressure limit reached. P, A, B or A and B pressure relief available. | Control flow. 2 positions. |
Type | Sub plate mount | Module. Mounts between directional valve and manifold/sub plate. | Module. Mounts between directional valve and manifold/sub plate. | Module. Mounts between directional valve and manifold/sub plate. | Module. Mounts between directional valve and manifold/sub plate. | Sub plate. |
|
|
|
---|---|---|
Hydraulic Cylinder Circuit Examples |
Hydraulic Motor Circuit Examples |
|
Pumps, Valves, Manifolds, Subplates, Power Units.