Feature

●★ACTUATOR HOUSING-- polyamide press, stainless steel.
●★SEAT VALVE--External pneumatic actuator, can increase service life, avoid maintenance.
●★ANGLE SEAT FEATURE--There is a self-regulating sealing gland between the overflow mouth and the sliding block, which can improve the sealing performance.
●★DOUBLE ACTING--In the non-working state, the action of the spring, the valve normally open or normally closed. When the actuator piston is compressed gas valve open or closed, double-acting form by compressed gas control valve switch.
●★TORQUE VALVE-- valve and pipe connections are tight enough torque required force, a force the size of torque values are as follows: DN32 to 150Nm.


Description

Parameter：
- Interface: DN32
- Control pressure: 0.3Mpa-1Mpa
- Body material: 304 stainless steel
- Pneumatic form: plastic head
- Spool seal: PTFE
- Stem seal: PTFE/FKM
- Piston seal: FKM/NBR
- Applicable medium: water, neutral gas or liquid, alcohol, oil, organic solvent, water vapor, weak acid or weak alkali solution
- Medium temperature: PTFE: -10 ° C - +180 ° C
- Ambient temperature: -10 °C - +60 °C
- Viscosity: up to 600MM2/s
- Control medium: air/neutral gas
- Control pressure range: 0.3-1MPA
- Installation: Install as needed, preferably with the actuator facing up
- Features: large flow, long life, maintenance free, reliable
- Widely used in: beer beverage filling equipment machinery, textile printing or bleaching, gas industry pharmaceutical and medical equipment, pharmacy, chemical industry high temperature sterilization, disinfection; foaming machinery, foaming equipment; water pollution treatment.

Installation and removal:
1.Connect the valve to the pipe to ensure that it is in the same direction as the flow and attached to the body (the outside of the body represents the direction of fluid flow, according to the installation);
2.please remove the actuator when welding installation;
3.threaded or flanged: correct installation;
4.Disassembly: Ensure that the pressure has been removed before disassembling the valve; carefully disassemble and properly store the thread and sealing material after removal.
5.The torque required for the connection of the valve and the pipeline is large enough. The torque value of the torque is as follows: DN32 to 150Nm
6.ensure that the pipeline and no residual interface when installing.
7.Make sure there are no leaks before use.

Package Included:
- 1*DN32 Angle Seat Valve