Feature
●??[Compatibility]: The home button is only compatible with iPad 7 7th generation 10.2" 2019 (A2197 A2198 A2200) and iPad 8 8th generation 10.2" 2020 (A2270, A2428, A2429, A2430). Please check the model number before purchasing this product. You will find the model number on the back of the device. (Please refer to the product picture on the left).
●??[High Quality]: New home button replacement parts, each part has been tested before shipment.
●?[Application]: Replacing the home button component will permanently lose the fingerprint touch ID function. But you can perform normal click functions. The Touch ID feature will be unavailable and cannot be restored because its pairing with each device is unique. For security reasons, only the original home button touch sensor is available on your iPad.
●? [Personal Installation]: Includes Home button with cord, speaker bracket, gasket and waterproof ring, which can be reassembled quickly and easily.
●??[After-sales service]: 3 months of non-human damage, we provide free replacement compensation. If you have any questions about installation tutorials, packages or products, please feel free to contact us via Amazon .
Description
Home button installation step description:
|
|
|
|
|
|---|---|---|---|
The first stepTake out the parts as shown in the picture, separate them with your fingers, and keep the parts marked by the arrows in the picture. |
The Second stepTear off the circle gasket reserved in the previous step, and stick the sticky side to the button hole on the back of the touch screen. Please align and paste as much as possible. |
The third stepTake out the buttons in the tool kit, as shown in the figure. |
The fourth stepPut the back of the button up, and then put it into the button hole, as shown in the figure. |
Home button installation step description:
|
|
|
|
|
|---|---|---|---|
The fifth stepTake out the parts (waterproof ring) as shown in the figure, and tear off the protective film. |
The sixth stepPaste the sticky side on the button hole, please pay attention to calibration. Through this step, the waterproof ring can initially fix the button cable on the touch screen, as indicated by the arrow. |
The seventh stepTake out the part (horns) as shown in the picture. The two sides of the part are sticky. |
The eighth stepPaste the sticky side of the part on the key hole of the touch screen, and the center of the part is aligned with the center of the key hole, and the key change is installed. At this point, you can test and press the button to see if the button can be pressed normally. If there is no response when pressing, please check whether the installation of all parts is fully calibrated. |
