â–²Technical Specification;
To Assemble and Install:
1.Unpack the unit completely and confirm that all pars are preset SEE FIGURES 6 above
2. Connect the repellent head, pole sections connecting part and ground stake. SEE FIGURES 5 above,
3. Turn power switch to "ON" position.
4. The PIR repellent is designed to be left ON continuously. It uses four 2/3 AA size NI-MH rechargeable batteries
5. .When the animal driver is delivered, the surface will be covered with a layer of film, which is not part of the product and needs to be removed. It is recommended to turn them off for the first time and turn them on after charging for 4-5 hours. turned ON,the Red-LED light and ultrasonic signal will activate for 15 seconds,Among the time there is sound waves for 2.5 seconds at the beginning.At the same time ,the White-Led lights flash blasting. Following this activation,The unit will move to stand-by mode.
6. The unit is now ready for installation, The location should allow adequate sunlight to keep the batteries fully charged. Be sure that the area needing protection is within the effective range of the repellent SEE FIGURES 3.
7. For best results,Adjust the height of the product properly so as to adapt to the height of animals and produce better detection
CAUTION:
Allow the Animal Repellent to operate continuously for best results.
Do not immerse repellent in water.
Do not cover-up the PIR sensor.
To clean the repellent, use a damp-soft cloth and mild soap with water. Do not use harsh chemicals or abrasive cleaning agents that may damage the repellent.Package Dimensions : 6.2 x 5.8 x 2.9 inches; 11.22 OuncesDate
First Available : July 29, 2030