Feature

●EXACT REPLACEMENT MANUAL TRANSMISSION GEAR SHIFTER BEZEL - This 2-pack shifter bezel is compatible with Cherokee XJ 1984 to 1994 models and Wrangler TJ 1997 to 2004 models. These are the models equipped with T4, AX4, T5, AX5, AX15, BA-10/5AX5, AX15, NV2550, or NV3550 manual transmission
●REPLACES OE 53000056 - Replace old, broken, or deteriorated factory bezel with direct replacements that fit and work like the original
●Each bezel has the same thickness, quality. Made from high-quality plastic, this bezel won’t warp, fade, or crack for years to come! It’s also UV, heat, impact, and tear-resistant
●EASY-TO-INSTALL SNAP-ON SHIFTER BEZEL - There’s no need for screws. These bezels go under the bottom of the rubber boot, securing it in place. Install the taller side first, facing the sidewall. Press the taller side first and then the opposite side. You will audibly hear the bezel snap in place into the center console


Description

Do you have a broken or deteriorated bezel?

Replace it now! Cracks can cause damage to the shifter boots bottom while deteriorated plastic can loosen the bezel, compromising its usability.

To remove damaged or deteriorated bezels, lightly press the sides of the bezel inwards and then pop out.

To install the replacement shifter bezel, insert it through the shifter boot with the front (the taller edge and with the snap-on clips at the bottom) end facing the dashboard. Drape the rubber boot over the bezel and gently press the bezel down on both ends until it clicks in place. The bezel will create a snug hold, preventing the boot from flopping around.

Take note that theres only one way to install this bezel so ensure that its facing the right way before pressing it into place.

Double-Check Compatibility

These rectangular plastic bezels fit boots and consoles equipped with T4, AX4, T5, AX5, AX15, or BA-10/5AX5 manual transmission for the Cherokee XJ 1984-1994 models and AX5, AX15, NV2550, or NV3550 manual transmission for the Wrangler TJ 1997-2004 models.

Unsure about the fit?

This shifter bezel is 6.25" long, 5.5" wide, and 4.5" high on its tallest end. The bezels shape and design ensure that it fits and snaps perfectly on its designated slot on the center console. Take measurements of both the boot and the console, especially if you are not aware of the type of manual transmission used on your model.

1 2 5 3 4
2 Pack License Plate Cover License Plate Cover & Plug Kit 2 Pack Tailgate Plug 2 Pack Shifter Bezel Foam Blocker Seal Kit
Ues for exterior exterior exterior interior exterior

Product information