STEP 1: Attach the 3-Way Diverter(Connect with Shower stem)
- Firstly , check whether there is a mesh gasket at the interface of the 3-way diverter connected to the outlet pipe end. (If not, place a spare gasket).
- Then wrap the joint of the outlet pipe clockwise for 8-10 circles of teflon tape.
- Then install the 3-way diverter on the outlet pipe by hand, and adjust the position of the 3-way diverter to the position as shown in the figure below. Finally, use a wrench with a diameter of 23 cm to tighten the 3-way diverter. (Notice: The inaccurate direction of the 3-way diverter will affect the use of the shower head combo.)
STEP 2: Install the Extension Arm(Connect with Diverter)
- Firstly check if there is a mesh spacer at the hexagonal interface A of the shower extension arm. (if not, place a spare gasket).
- Then wrap 8-10 circles of teflon tape clockwise at the water outlet A of the 3-way diverter.
- Then install the shower extension arm to the outlet A of the 3-way diverter by hand. Then use a wrench with a diameter of 24 cm to tighten the shower extension arm.
STEP 3: Install the Rain Shower Head(Connect with Shower Extension Arm)
- Firstly check whether there is a mesh gasket at the interface A of the shower head. (if not, place a spare gasket).
- Then wrap 8-10 circles of teflon tape clockwise at the other end B of the shower extension arm.
- Then install the shower head to the other end B of the shower extension arm by hand. Then use a wrench with a diameter of 22 cm to tighten the shower head.
- Finally, rotate the buttons A-B at both ends of the shower extension arm, and adjust the shower head to the position that suits you.
STEP 4 & 5: Install the Shower Hose and Handheld Shower Head (Connect with Diverter)
- Firstly make sure the washer is placed in A & B head connector (Can also not add washer).
- Connect the A head of the shower hose to the B interfaceof the 3-way diverter.
- Connect the B head of the shower hose to the handheld shower head.
- Finally, insert the handheld shower head into the shower holder of the 3-way diverter and adjust it to a suitable position.
STEP 6: Install the Shower head Holder
- firstly clean and dry the wall. (Notice: material of the wall) .
- Tear off the protective film on the back of the shower head holder, then stick the shower head holder on the wall and press it firmly. (Notice: After the shower head holder are installed, it is recommended to use it after 4 hours.) .