Instructions for Car Dent Puller
Note:
1. When dealing with car dent, only for the flat surface, not for the curved surface
2. Please make sure that the dent are in the flat surface and should be larger than the bottom suction cup diameter
3. The product does not work on wooden surfaces
4. Always try to make sure there is good suction before lifting
5. Must be used on clean, smooth, flat, non-porous surfaces
6. Please store the suction cup in clean, dry condition
Must be used on clean, smooth, flat, non-porous, dry surfaces. Always try to make sure there is good suction before lifting. When dealing with car dent, please make sure the dent is on a flat surface and the diameter should be large than the diameter of the bottom of the suction cup.
1.Before using the dent puller kit, pour hot water at 80-100℃(176-212℉) on the dent area.
2.After pouring the hot water, Dry the water quickly with a towel, quickly place the suction cup on the dent of the car,and then pull it out horizontally.
3. When the recessed area of the vehicle is extremely irregular, the method of multi-point adsorption and simultaneous pulling can be used.