[1987-2006 Jeep Wrangler YJ TJ]
[2007-2018 Jeep Wrangler JK]
1 pair of tail light cover guards
1 set of mounting screws
|
|
|
---|---|---|
High QualityForged with aluminum alloy and coated with anti-corrosion coating. It is strong and durable, which can not only prevent rust and corrosion, but also not easy to deform. |
Flying Flag PatternThe flag flying with the wind can show your relaxed and happy mood when off-roading. Just add a little Jeep Wrangler accessory and it will change the look of the JK and show your attitude. |
Protect Vehicle TaillightsThe solid aluminum alloy material can effectively prevent the tail lamp from being scratched. Extend the service life of the tail lamp. |
|
|
|
---|---|---|
1.Remove the four mounting hole screws from the original car. |
2.The tail lamp cover is covered with screws and rubber rings and fixed on the tail lamp. |
3.Put the rubber rings and screws on the remaining three holes respectively, and then tighten the screws. |
JROAD rear fender fits Jeep Wrangler JK | JROAD tubular door fits Jeep Wrangler JK | JROAD front bumper fits Jeep Wrangler JK | JROAD tubular door fits Jeep Wrangler JK | JROAD Front Inner Fenders Jeep Wrangler JL | JROAD JK Soldier Front & Rear Inner Fender | |
---|---|---|---|---|---|---|
Compatibility | Jeep Wrangler JK JKU | Jeep Wrangler JK | Jeep Wrangler JK JKU | Jeep Wrangler JK JKU | Jeep Wrangler JK JKU | Jeep Wrangler JK JKU |
Years | 2007-2018 | 2007-2018 | 2007-2018 | 2007-2018 | 2007-2018 | 2007-2018 |
Material | Aluminum | Steel | Steel | Steel | Aluminum | Aluminum |
Installation | Bolt-on | Bolt-on | Bolt-on | Bolt-on | Bolt-on | Bolt-on |
Cutting Required | No Drilling | No Drilling | No Drilling | No Drilling | No Drilling | No Drilling |
Coating | Powder Coated Finish | Powder Coated Finish | Powder Coated Finish | Powder Coated Finish | Powder Coated Finish | Powder Coated Finish |