Specification:
Item Type: Servo
Material: Plastic, Aluminum
Model: S2300M
Color: Black red
Blocking Torsion: 7.4V≥32Kgf.cm.6.0V≥25Kgf.cm
Stopping Torsion: 7.4V 23Kgf.cm. 6.0V 20Kgf.cm
Operating Voltage: 6.0 ~ 7.4V DC
No Load Speed: 6.0V≤ 0.20sec / 60°; 7.4V≤0.17sec/ 60°
Operating Angle: 180°±10° (500 ~ 2500μs)
Mechanical Angle: 360°
Enclosure Material: PA + 30% GF, aluminum medium shell
Gear Set Material: Metal gear
Motor Type: DC motor
Size: Approx. 44.3 x 40 x 20mm / 1.7 x 1.6 x 0.8in
Fitment: Fit for 1/8 1/10 RC Model
Installation Instructions:
1. Install the steering gear to the steering gear base first, and do not install the steering gear arm or the steering gear protection. Fix the steering gear to frame only. Then the steering gear is connected to the receiver, generally CH1 or ST socket is divided into three wires. Bottom line, VCC, signal /PWN.
2. After the steering gear is fixed, turn on the remote control, set up and turn on the ESC, and then the steering gear will stop in a fixed position
3. In the case of not closing the remote control and steering gear, the steering gear protection or steering gear arm is installed to the steering gear output teeth
Package List:
1 x 23KG Servo
5 x Servo Arm
5 x Screw
8 x Accessory
1 x Manual
Note:
1. Please allow 1?3mm error due to manual measurement. Thanks for your understanding.