Feature

●Applicable models: Wanhao i3,Cocoon Create 3D Printer ,Monoprice Maker Select 3D Printer v2
●Product advantage:Slotted Clamping system,no set screw to ding and damage thermal tube, significantly better heat transfer,Easier disassemble and adjustments,precise control on bore diameter
●Orifice size available:0.4mm, nozzle plated with high lubricity wear resistant coating
●Kit Includes: Wear resistant nozzle,thermal tube,slotted cooling block
●Warranty: 30 days money back or exchange,if you met problem with your kit, we will solve the problem within 24 hours, JUST MESSAGE US BEFORE LEAVING A REVIEW. We can not guarantee 0% defective rate, but we guarantee 100% satisfaction


Description

Color: silver

Packing size: 11*13*1CM

Kit weight: 36.8G

Orifice size available: 0.4mm

Applicable models:
Wanhao i3
Wanhao i3 Plus
Monoprice Maker Select 3D Printer v2
Monoprice Maker Select Plus
Cocoon Create 3D Printer

Kit Includes:
1*Wear resistant nozzle
1*Thermal tube
1*Slotted cooling block

All metal hotend kit features:

All metal hotend upgrade for MK10 style extruders. This upgrade includes a modified thermal barrier tube and modified nozzle with modified cooling block. Thermal barrier tube is made from 2 different materials. The lower thermal break is made from stainless steel, and the colder upper part is made from aluminum. Stainless steel was used for thermal break because it offers low thermal conductivity, and aluminum was used for the upper portion because it has a lot better thermal conductivity, to carry away any heat from the filament. All metal hotend will let you print at much higher temperature than possible with original PTFE lined one. Another benefit of an all metal hotend design is more consistent melt chamber control. During slow extrusion rate, in PTFE lined hotend, transition zone from solid to molten plastic tends to creep upward creating more stringy prints. With all metal design a transition zone is always constant, being located right at the heat break. With fast extrusion rate, PTFE tube doesnt have enough thermal conductivity to properly melt all the plastic coming out. On MK10 extruders that limitation happens around 60 mm/s, depending on nozzle size. All metal hotend solves this problem, plastic is surrounded by thermally conductive nozzle throughout its length.