Scope of application: It is used for other Nanovna and SMD
Specification:
Item Type: 3G Vector Network Analyzer
Material: PCB + acrylic
Colour: Black
Frequency Range: 50KHz-3GHz
System Dynamic Range (calibrated): 70dB (up to 1.5GHz), 60dB (up to 3GHz)
S11 Noise Floor (calibrated): -50dB (up to 1.5GHz), -40dB (up to 3GHz)
Sweep Rate: 100 points/sec
Display Screen: 2.8 inches, 320 x 240
Size: Approx. 7.1cm / 2.8in
USB Interface: Micro USB
Power Supply: USB, maximum charging current 1A
Battery: 1 x Lithium battery, 1950mAh (included)
Battery Connector: JST-XH 2.54mm
Maximum S Scan Point (on The Device): 201
Maximum S Scan Point (USB): 1024
Port 2 Return Loss (1.5GHz): 20dB typical
Port 2 Return Loss (3GHz): Minimum 13dB
Package List:
1 x Vector Network Analyzer
1 x Micro USB Data Cable
2 x 300mm Sma Male to Male Ss405 Rf Cable
3 x SMA Nut Connector
10 x Ring
1 x Plastic Pen
1 x English User Manual
Note:
1. It uses a user interface similar to NanoVNA, but uses a different technical architecture.
2. It will not load the initial calibration data at startup, and will not automatically insert the calibration data after the user changes the frequency.
3. After each startup and frequency change, you must re?calibrate or recall calibration data.
4. Please read the instructions carefully before use to avoid damage to the equipment.