[8-PACK]
Compatible with Various Types of Magnetic Phone Holders
Various Location: Air Vent / CD Slot / Dashboard / Windshield / Suction Cup / Cup Car Mount/Bicycle / Vehicle / Universal and all Magnetic Phone Mount.
Compatible with Popsockets Grip
1. Only 1.57 Round Mount Metal Plate can Work for Pop sockets Grip.
2. Only Stick on Outside of the Callapsible Grip & Stand, NOT Inside.
3. Easy Use: Pop out the Grip, Stick the Plate onto the Cap, then it is Compatible with Magnetic Mount.
4. Super Thin, almost NOT Add the Thickness of POPsockets.
|
|
|
---|---|---|
Strong Adhesive1.The back of the metal plate with strong adhesive, it make the metal plate will not easy to fall off. |
Super Thin2.It is very thin and can better fit the surface of the phone or phone case.Widely Compatible with ALL Smartphones without Textured / Curved Surface. |
Work Great3.Work great with Magnetic Mobile Phone Car Mounts |
1. AVOID AFFECTING WIRELESS CHARGING, Please Place Metal Plate on the Phone AWAY FROM WIRELESS CHARGING SENSOR;or Place Metal Plate on Phone Case,Please Remove the Phone Case before Wireless Charging.
2. These Metal Plates with 3M Adhesive Can NOT be Reused after Removaled, Can NOT Used as Toys for Babies and Children.
3. All of the Metal Plates have no Magnets, and They Do Not Have any Magnetism.It just Replacements Plates for Magnetic Car Mounts.
4. Not Recommend to Apply on the Leather / Silicone / Soft Case, or with Textured / Curved Surface.If the Back of the Phone isCurved Glass, it is Recommended to Stick the Metal Plate on the Flat and Smooth Phone Case.
|
|
|
|
---|---|---|---|
Step 1Clean and Dry the Surface of your Phone / Phone Case with the Alcohol Pack. |
Step 2Tear off the Transparent Protective Film and Stick it on the Back of Phone or Phone Case |
Step 3Peel Off the Sticker and Place the Metal Plate on the Transparent Protective Film of the Phones / Cases Surface.Adhere with Finger or Hand Pressure on it for Consistent 20 Seconds. |
Step 4Suggest you Wait for 24 Hours before Using to Make Sure it Firmly.Use Hair Dryer to Blow Hot Wind on it to Melt the Adhesive to Remove it. |
You can Place it Inside or Outside of Phone Case / Back of Phone.
1. 4* Round Mount Metal Plate (1.57" in diameter )
2. 4* Rectangular Mount Metal Plate ( 2.56" x 1.77" )
3. 2*Alcohol dry and wet pack
4. 4*round protective film, 4*rectangular protective film