How to Use:
1. Install the grinding head: put the grinding head into the collet and tighten the fastening screw of the grinding head with the matching Hex wrench
2. Startup use: gently press the startup key once to enter the 1 level working state, and the speed is about 5000 rpm
Press the start button again to enter the working state of level 2 for about 10000 revolutions
Gently press the start button again to enter the working state of level 3 for about 18000 revolutions
Press the start button again to enter the shutdown state
During use, the load display will display the load status at any time according to the use situation. When the use load is too large, the overload display light will be on for 2 seconds, and the overload system will shut down for protection,
If you need to continue to use it, you can press the start button again to start it.
According to the current situation of use, the user can master the load. Please use it within the overload range
Specification:
Item Type: Electric Punching Engraving Pen
Material: Aluminum Alloy , Electronic Components
Battery Capacity: Lithium Battery 300mAh (Shipped with Built in Battery)
Collet Depth: Approx. 25mm / 1in
Applicable Grinding Head Handle Size: Approx. 3mm / 0.11in
Power: 10W
Charging: 30 Minutes to 80%, Full Charge in 60 Minutes
Service Time: No Load Operation of 3 Level for More Than 1H (if It Needs to Be Used for a Long Time, It Can Be Used While Flushing)
Level: 3 Level
Speed: 5000-10000-18000rpm
Package List:
1 x Polishing Pen
1 x Hex Wrench
1 x User Manual
1 x Charging Line
7 x Grinding Head
Note:
Delivered with a built?in battery