This Pro-tek frame slider kit is made from acetal plastic for strength and durability. It requires modifications to both fairings.
It comes with all steel bolts, mounting hardware and complete instructions needed for installation.
The kit contains two acetal pucks with aluminum shims and steel bolts that clear the fairings by an inch.
You do not want a slider to stick out too far causing a bike to flip in a crash by snagging on the ground. You want the puck to either touch down and start to grind off or if hit hard enough or direct enough to shatter and absorb the initial crash energy. If the slider shatters, grinds off or bends, it did its job in absorbing the crash energy. You dont want it transferring the energy to other parts of the bike causing more costly damage.
Both pucks measure 102mm (4") in length and use 10mm x 90mm countersunk bolts.
These frame sliders are brand new in original packaging manufactured in the US from Pro-tek, a leading manufacturer in the motorcycle industry now for 25 years.
Applications
1997-2007 Honda CBR-1100XX
The frame sliders are mounted to the upper engine mounts. The fairings require modification during installation. This is best done by removing the fairing. Locate the engine mount bolt & replace with the supplied bolt. If heat shield foam is not present, apply play dough to inside fairing where cutting will take place. Put the fairing back and see where the bolt head has left an impression in dough/heat foam. This is the center of hole to be drilled. Mask outside of fairing with tape to prevent chipping during drilling. Take 2" hole saw and center around bolt head impression in dough. Drill through fairing. Lightly file down rough edges around hole. Install protector and replace the fairings. Comes complete with 2 10mm x 1.25 pitch x 90mm bolts & bushings.