Feature

●▶ Upgraded stainless steel wheel nylon wheel, no longer worried about damage，upgrade folder for quick blade replacement mode, change blades in one step.
●▶ Easy installation, all the parts after computer work planning, laser cutting, with precision.
●▶ Flexible as long as there is a small piece of flat work surface can be used. The use of energy, through the reasonable design of part angle coordinate
●▶ Easy to maintain: the whole machine adopts aluminum bracket, stainless steel screws, stainless steel holder, dont have to worry about the rust problem.The most commonly used double-sided razor blade, cutting tool and three holes blade support most of the industry.
●▶ Package Included: 4 x bracket; 1 x semicircle measuring tape; 8 x Retention tab; 5 x plastic cover; 15 x screws; 2 x wrench; 1 x screwdriver; 1 x G Clamp; 1x Blade.


Description

Specifications:
Color: Silver
Material: Aluminum
Size: 165x145x118mm/6.5*5.7*4.6 inch
Suitable For: Leather skiving

Installation Step:
1. Put into built-screw nut,and the screw nut is inside
2. Install rectangular connectors
3. Connect the two thick aluminum
4. Connect the two thin aluminum
5. Screwed into the screw can be fixed
6. Install the other rectangular connectors
7. Connect the beams and columns
8. Install Loading bay
9. Install the stainless steel round,it recommended tightening the screws and non-rotating wheel to prevent slipping and hurt fingers;If you want to rotate feeding,just loose screws
10. Use the longest screws fix the Loading bay
11. Install the blade and screw with a hexagonal wrench
12. Installed the semicircle base
13. Use G clamp fix on the machine table

Package Included:
4 x bracket
1 x semicircle measuring tape
8 x Retention tab
5 x plastic cover
15 x screws
2 x wrench
1 x screwdriver
1 x G Clamp
1x Blade

Kind Note:
1. Before use pls make sure that all screws are tightened and Aluminum will not shift and shake when we use force;Machine and work surface using G clamp to fix;Vertical and horizontal of aluminum is in good condition.
2. The peak mouth of blade and the surface of stainless steel round keep parallel before use.
3. Viewed from the side,the peak mouth of blade and the centerline of the wheel apart about 3mm because blade too far back lead to the leather get stuck and cant pull them.
4. Blade clamp must tighten with a screwdriver and wrench.